The primary product is a series of CPU boards based on the BRE440 CPU intended for use in BRE's Integrated Avionics Units or standalone C&DH systems. The first product in this lineup is the BRE Starter 440 Board, a commercial version CPU board intended to allow early system and software development starting now. Starting in early 2008, BRE will make available the first EM version CPU board based on the BRE440 Rad-Hard CPU, followed in mid 2008 by a flight version of the same.

The EM and flight boards will be very similar in functionality and performance to the BRE Starter 440 Board in order to enable quick drop-in replacement. With this, the BRE440 architecture is available now for applications that intend to deploy in late 2008.

• High Performance 440GP/BRE440 Chip w/ PowerPC440 Core
• On-Chip 8kB SRAM
• Processor Speed at >200MHz / 400MIPS
• 256MB Double Data Rate (DDR) Synchronous DRAM
• 32-Bit DRAM Interface with EDAC at 100Mhz
• External Peripheral Bus for up to 8 Mbytes of Boot-ROM
• DMA Support for External Peripherals, Internal UART and
• Memory
• PCI V2.2, 32/64-bit, 33/66MHz, Slot 1 Operation
• Ethernet Port 10/100Mbps Half- or Full-Duplex
• Programmable Interrupt Controller
• General Purpose Timers
• Two Serial Ports (16750 UART, RS232/RS422 Compatible)
• IIC Interface for Configuration ROM
• TRACE/JTAG Interface to CPU
• Internal Processor Local Bus Running
• at DDR SRAM Frequency
• 3U CompactPCI Form Factor, Compatible with Commercial
• Chassis and BRE Avionics

BRE440 Based Flight Board

• Ethernet via LVDS
• >1MB NVRAM
• SEL Immune
• Derated to 30kRad (100kRad Option)
• Conduction Cooled Design